|
Availability: In Stock
Digium TE205P E1 & T1/J1 Asterisk Card
The Digium TE205P is the next generation of hardware that improves performance
and scalability through bus mastering architecture. Both E1
and T1/J1 environments are supported on the TE205P - selectable on a per-card or per-port basis. This enables signaling translation between E1 and T1/J1 equipment and allows
inexpensive T1/J1 channel banks to connect with E1 circuits. Because the TE205P
improves I/O speed over slave-only architecture, the result is reduced CPU usage
and increased card density per server.
The Digium TE205P has been designed to be fully compatible with existing software
applications and is fully integrated with the open-source Asterisk PBX/IVR
platform. In addition, the open source driver supports an API interface for custom
application development. Using Digium hardware and Asterisk, numerous combinations of telephony configurations are possible. From
the traditional PBX to VoIP Gateways, Digium solutions are paving the way for
a new generation of worldwide communications.
The TE205P supports industry standard telephony and data protocols, including
Primary Rate ISDN (both N. American and Standard Euro) protocol families for
voice, PPP, Cisco, HDLC, and Frame Relay data modes. Both line-side and trunk-side
interfaces are supported, also included are advanced call features. The TE205P
is for use only with a 5.0-volt PCI slot. The TE210P is for use only with a
3.3-volt PCI slot.
Data Modes:
Cisco HDLC
HDLC
PPP
Multilink PPP
Frame Relay
Voice Modes:
PRI CPE & PRI NET
NI1
NI2
EuroISDN
4ESS (AT&T)
5ESS (Lucent)
DMS100
E&M
Wink
Feature Group B
Feature Group D
FXO & FXS
Ground Start
Loop Start
Loop Start with Disconnect Detect
|
